quick Cuttlebug help

[Mary JB]

I went to Michael's and purchased some Sizzix Dies to use in my Cuttlebug.
I think I sandwiched them right but can not run them through. The handle is way to tight and I can't turn it. My layering from the bottom is A B Die paper and C.
Please help me. Thanks M

[robynstamps]

If you check out the Cuttlebug sticky in the Tools & Products section I think it has a guide to use with all different dies in your CB.

Good luck!

[Mary JB]

I also forgot to ask. When everyone was getting there Cuttlebug I wasn't paying attention and there were many suggestions as how to layer brass stencils, texture plates etc. Is there a spot I could look to for a tutortorial or something because now that I have one, I am in the dark on a lot of these things. Thanks

[*SeikasHaven*]

Plate “A”, Die, Cardstock, Plate “B”, Chipboard slim
Also try:
Plate “B”, Cardstock, Die, Chipboard slim (maybe 6 layers)

[*SeikasHaven*]

For how to "sandwich" stencils and other companies dies go here

[floridagal]

Quote:

Originally Posted by Mary JB

I went to Michael's and purchased some Sizzix Dies to use in my Cuttlebug.
I think I sandwiched them right but can not run them through. The handle is way to tight and I can't turn it. My layering from the bottom is A B Die paper and C.
Please help me. Thanks M

I have one and I use the bottom plate, then B then cardstock,then B again and I have no trouble with that

[Mary JB]

Thank you all so much! The site with the chart is awesome! It is amazing what a person will do to make this craft so much fun. Thanks everyone! Mary