Magic card instructions
1. Stamp acetate with stamp and stazon ink. Put aside to dry.
2. Fold into quarters 1 - 8 1/2 x 11 cardstock.
3. Cut 1/2 " off right side facing you, keeping the 1/2" scrap.
4. Cut left top quarter out - put aside for future use.
5. Make a 1/4" fold on bottom left.
6. Fold top right down over the bottom right.
7. On fold cut 3 3/4" slot in center about 3/16".
8. Take cardstock that you put aside and stamp image with classic black
ink (your image on the acetate should line up with the new image).
Color new image.
9. Stamp bottom left with image which lines up with the image behind or
cut circle/square out that frames the image that is behind.
10. Place acetate over cardstock lining up images, cut both to fit through
the slot on the right hand side of card.
11. Tape acetate and cardstock on the top keeping them in line. Open
and tape on reverse side for re-enforcement.
12. Make a pull tab from 1/2" strip previously cut off and tape to top of
acetate.
13. Insert taped cardstock through slot making sure acetate goes over
the slot.
14. Fold bottom left quarter over and seal the 3/16" fold to the back of
the bottom right quarter.
I just did this card at a workshop. It was the first time I had made it, and I think it's a good idea to make it with another person. Two heads are better than one!!! A very cute card, can be a little confusing. The more you make it, the easier it gets.
Have fun,
Debbie
|