Hello everyone!
Here is a Christmas gift card holder I made. Inside there are 2 slots, one for the gift card the other is for the sender to send a message in.
Hope you like it!
Date: Tuesday, October 30, 2007 GMT Views: 2913
Favorited:45
Registered: June 20, 2006 Location: Saskatchewan, Canada Posts: 2422
Sun, Nov 04, 2007 @ 4:59 PM
Here are my directions for this. I found them on a blog and for the life of me I don't remember where!
First cut cs 4 1/4 inch by 11. Fold this in half. Use your word window punch and punch the top open end so it looks like the place you would put your fingers through.
Next take a business envelope and seal the opening. Fold in half and cut the ends off. I use double sided tape and tape down the center of the inside of the fold. Then place more tape down the center of the cs on both sides and place the folded envelope inside the card. when you go to open the card it looks like an accordian; there are 2 little pockets. One pocket is for a gift card and the other is where you would put a note.
I hope I explained this ok.
Just ask if there are any problems.
Kim
------------------------------ Kim My Gallery My Blog Proud Grandmother to Avery and Quinn!