Flutter Butterfly Pin All Stamps Sparkle N Sprinkle
Stamps:
Heart Butterfly Large 0768-160K
Accessories:
E6000 Glue Craft Store
Purple Spark EP196
Transparency Office Supply Store
Anti Static Bag 99512
Versa Mark Ink 99702
Pin Back Craft Store
Instructions:
1.Prepare transparency by whipping surface with the anti static bag. Please note, your hands should be very clean and free of oil, if they are not you will leave finger prints on your finished project.
2.Using Versa Mark Ink, stamp butterfly onto the transparency, I was able to stamp eight images for a total of four pins.
3.Sprinkle Purple Spark, remove excess and slowly and from a farther distance than usual heat setting, heat set the image. Being careful not to burn or melt the transparency.
4.Cut out the butterflies.
5.Using the E6000 glue, apply a small bead on top of one image and apply the second on top. Set aside to dry.
6.Add the pin back up and down the bugs torso (So it doesnÂ’t show) with the E6000 glue. Allow to dry.
7.When completely dry (about 30 minutes) gently crease the top wings (Which I separated the two halves with scissors) toward the middle and crease. If you are careful you will not crack the embossing.
Date: Saturday, March 22, 2008 GMT Views: 1578
Favorited:18
Registered: August 25, 2005 Location: Tri-statecarea of Arizona Posts: 25
Tue, Mar 25, 2008 @ 4:09 PM
Such a beautiful pin!!!!!
You said:
"When completely dry (about 30 minutes) gently crease the top wings (Which I separated the two halves with scissors) toward the middle and crease. If you are careful you will not crack the embossing."
Could you explain the separting with the scissors. That confused this simple mind.
Registered: September 20, 2004 Location: In my stamp room Posts: 3068
Wed, Mar 26, 2008 @ 7:17 AM
Sheila and everyone;
I use scisors to cut the wings apart at the lower junction, it is obvious when you look at the pin. it just helps them to look like they are in flight. Thanks for asking.