Cut your tissue paper to fit around the votive. Stamp your design on by coloring with markers directly on the rubber. You will need to "huff" on the image before you stamp it onto the tissue paper. Repeat until you have the amount of flowers you desire. Once your tissue paper is done to your satisfaction set it aside. Take your Crystal Effects and pour some on the glass to cover. Don't make it too thin that it dries too quickly and don't make it too thick either or the ink will run and smear. Now that your votive is covered pick up your tissue paper and set it in place. Start with the middle of the tissue and just drape it on, slowly going around each side to adhere it. If it overlaps you may want to put a little Crystal Effects on it to make it stick. Now you will repeat the Crystal Effects application you just did. Make sure your beads are poured into a container that will allow you to have room to roll the votive in it. Roll your votive in the beads, dump out any beads on the inside before you remove it from the container. If there are bare spots you can touch them up by adding a little Crystal Effects and more beads. If it appears lumpy you can take the metal part of the paint brush and push them down so it's flatter. Set it aside to dry. This should take about 20 minutes or so. When it's dry you are going to add one more layer of Crystal Effects to it to adhere the beads to the tissue. Once it's dry the beads will no longer flake off in your hands. Insert a candle and it will make a fabulous gift!