Instructions: You will need three 8.5x 11 pieces of thinner cardboard for this project. Panel 1 is 6-3/8 x 6. Panel 2 is 5-3/8 x 6. The Album pieces are 3-7/8 x 6-1/8.
On Panel 1, score 1 inch along the top, left, and bottom. On the right side, from the 1-inch score lines, measure 1-5/16. This will guide you to where you should place the 1-3/8 circle punch. You will also need to cut 1-inch along the top and bottom score lines, as marked by the diamonds in the picture.
On Panel 2, follow the same instructions as Panel 1, EXCEPT for the cutting part. Panel 2 will be attached to the inside of Panel 1, therefore it has no end part or cutting required.
Attach the panels together. I covered mine with designer paper first, then attached them, and then to cover up any ugly edges, I cut a piece that was 6x3, scored it, and glued it over.
The album pieces need to be scored at 7/8. To place the 1/8 holes, you need to measure 3/4 from the top, then 7/16 from the outside. Where these intersect, is where you need to punch. Place brads on the outside. You can choose to place pages in between the two album pieces, or on top of both. The pages should be 3-3/4x5-3/4. However, I suggest that the majority of your artwork be between 3-3/4x 4-7/8
Date: Monday, July 17, 2006 GMT Views: 3751