Registered: April 7, 2004 Location: Washington Posts: 1197
Thu, Sep 02, 2004 @ 11:08 PM
TThanks for the nice comments. The dimensions would vary based on your sucker but this one is 5.5 x 2.75 for the base and then the layers are each 1/4 inch smaller. I used the 1 3/8 punch for the hole. It won't go through 3 layers of cs, btw --- note the tearing. I stamped on a piece of window sheet using black staz on. Use mono to make everything stick together and along the sides and bottom of the base layer. 1/8" punch on either side of the stick and tie ribbon through the holes. It's quite easy and would be fun to demo.