Registered: May 20, 2005 Location: sacramento, ca Posts: 5006
Sat, Sep 03, 2005 @ 1:29 PM
Here is what I did. I stamped the image on the white cardstock. Then I cut it out leaving a small margin on all sides. I left a bit larger margin on the top. Then I folded the left and right sides so that the bottom was wider than the top. Then I folded the bottom up and then the top. I taped all the ends down in the back and snipped the over hanging piece if there is any. Then punch two holes in the top for the wire. I took the wire maybe 4 inches folded it in half and twisted it then put it in the holes and taped it down in the back. Then I put dimensionals on the back and adhered it to the card. That's it. I finally have a use for my garden block set. Woo Hoo!!
"Think of all the money I will save by making my own cards"
Registered: March 14, 2004 Location: 16 LOSTie Lane Posts: 54962
Sat, Sep 03, 2005 @ 2:13 PM
This is super cute! Thanks for the directions on how you did it.