Stampin up Jumbo Wheel

[Stampinmom57]

I unmounted the shop around jumbo wheel so I could use it as a stamp. Problem is what do I mount it to. The measurements are 2x7. I have never done this before but I seen a video on unmounting wheels.
Thanks for any help you can give me.
Sheri

[Mrs Noofy]

I use a long acrylic block that I got at a craft show. I use a couple of pieces of double sided tape to hold it on when I use it. Works for me and the unmounted ones are so much easier to store than the wheels. Hope this helps.

[Brenda71]

If you want the cling foam backing on it, you'll need something like the EZ Mount foam. And you can get an acrylic block that is that big. Or with that wheel, I think you should be able to cut it apart for several stamps. HTH

[Stampinmom57]

Thank you for the information. Maybe I will cut it to card size, then it will fit on my stampin up clear block.

[Mrs Noofy]

You can always tape your acrylic blocks together as long as they are the same height instead of cutting your stamp...just in case you want to make a longer card later. That's what I do sometimes.

[Skippet]

I use the Fiskars Easy Stamp Press and double sided tape for my unmounted wheels. It has a 7" x 5" layout area and works great if you run your hand over the entire wheel while holding the press down. Just make sure you don't get the Fiskars Compact Stamp Press because the layout space is too small for use with the unmounted wheels.

[jah636]

Mount it onto cling mount (I'm not sure if SU still carries it) and then I bought a clear block just the right size from Gina K.