Quickutz Silhouette Prob.
Hi you all I am hoping there is a silhouette guru on here
I have 2 questions
1- I am cutting out letters from iron on material. Which side do I print and then cut on to get it to turn out right.
2-speaking of printing-what I meant was I am tracing around them first then want to cut them out-however, every attempt I make cuts most of the ink part off that I just traced. Isn't it suppose to be put in the pen mode-trace out whatever image then leaving the carrying sheet alone replace the pen with a blade and proceed to cut it out?
I am running out of iron on sheets and want to finish this tonight if at all possible. Thanks bunches!
|
