nestabilities sandwich
Ok so I use the nestabilities with my CB and I found the sandwich that works for me is:
(Stack from bottom up) 1. A plate 2. C plate 3. nestabilitie die face up 4. cardstock 5. B plate which is from Nicole's (Papertreyink) blog and it works for me. I find it hard to make sure that the die is cutting where I want it to cut especially if I have stamped my image before I cut (I know the simple answer would be to cut then stamp but sometimes my plans change and I want to cut after). Can I change the order of my sandwich making it: (Stack from bottom up) 1. A plate 2. B plate 3. cardstock 4. nestabilitie die face down 5. C plate now to me this sandwich makes more sense, the CS is face up so I can see what I have stamped and where the die will cut and the die is facing down so it is still cutting into the B plate and not my C plate. Just curious as to why I couldn't do it this way and why everyone else has been doing it the other way? |
oooh good question, I am curious to know too!!
Lori |
I try to place the plates so I'm always cutting into a B. Yes - I've forgotten a few times but I can still mostly see through my C plate.
I think the order matters more when you're embossing then when you're cutting. |
I do it the way you are asking about and it works fine. I always want to see where my die is on the paper.
Blessings. |
OKay, so I just got my first set of Nesties! I have two questions:
1. How do I get them to emboss? 2. Are the nesties supposed to be cutting into the b plate or the c plate? My c plate has marks on it from where I was just playing. Is this supposed to be the case or am I doing something wrong? |
Quote:
2. Yup. Try to keep the marks going into the same plate. |
All times are GMT -8. The time now is 09:50 AM. |