how do you do this
 

i think this was a swap a while back, trying to look for instructions but can't find any....anyone can point me in the right direction?

http:////www.splitcoaststampers.com/...4464?limit=all

Not sure what you need instructions for sorry ? Is it the tag ?

instructions
 

what i really need is measurements for the front 'triangle' piece....? i know it looks really basic, but is there a 'specific' measurement for it?
thanks!

Hi this Sketch Challenge #65. These are the instructions Rox71 advised us to use. Hope this helps, Sue

I’m using my own sketch this week and many of you have seen it already.
The card size is the 5.5 by 4.25”.
The panel is cut 3.75 (one half inch narrower than the card).
Measure one inch in from each bottom edge and make a mark.
Line up the corner and the mark on your cutter and make the cut.
I made a template from an old greeting card so it’s faster measuring the next time.
You can use the panel in either direction, decorative scissor edges are optional and here are two samples:

Try this.. look at the original post on this thread
http:////www.splitcoaststampers.com/...=237896&page=7

This was for a sketch challenge and this may help.

thanks for the help
 

to everyone, this is what i needed!