Tack N' Peel???

[scrapmo]

Got the tack n' peel, got the blocks, now I need to put them together. The directions are so not helpful. Are both sides the same? Or is one sticky and one tacky? One side protector sheet is yellow, the other is clear. I am thinking I stick the yellow side to the block and it stays stuck.

[kelsluvs2scrap]

From http://www.tsukineko.com/new2.php
INSTRUCTIONS

Place block on the yellow side of the Tack �n Peel sheet and trace the outline with a thin permanent marker.
Use scissors or craft knife to cut out the traced shape.
Peel off the yellow liner from the Tack �n Peel and place onto the block or handle.
Remove the clear liner but do not discard.
Place your unmounted stamp or any found object onto exposed side and begin your stamping project!
When finished, remove the stamp or design object and replace the saved clear liner to protect the surface until ready to use again.
(Caution, unmounted stamp or design object should be removed for proper storage to prevent difficulty in removing later.)
When ready for re-use, restore tackiness by just wiping the surface with a wet cloth or rinse with water if needed, and allow to air dry.

[scrapmo]

Cool, thanks - they should have put that on the package!