Question on the Misti Creative Corners

[maslex]

I was wondering if the Creative Corners work in any other "stamping platform".

I have the Tim Holtz traveling platform (roughly 6.5 x 6.5) and would like to get the Misti Creative Corners but not sure if they'd be compatible with the Tim Holtz stamping platform.

Curious if I should just order them or if I should just get a Misti and then buy all the accessories to go with it? Thanks!!!

[bjeans]

I’ve used Creative Corners in my Mini Misti and Tim positioners. Chipboard works too - I think Shaz made chipboard jigs? Even carefully cut and stacked CS works, if a trimmer doesn’t like chipboard and Exacto cutting isn’t fun. I’ve even grabbed an ancient 6” plastic ruler. They just need an edge to butt against though I suppose adhering them in the middle with removable tape might work.

They work because positioners are made to work with thin (photopolymer or naked rubber) and thick (mounted rubber) stamps. And Creative Corners are made to work with those stamps. I really like them though forget to use them in more creative ways that videos show.

[shazsilverwolf]

Just had a look at an image online, and can't see any reason why they won't work with Tims platform. They just look to be a typical 90 degree angle.

[shazsilverwolf]

I did cut myself something similar out of chipboard, just so I could position some stamps to hang over the edge. I didn't make corners though, I just cut two strips of chipboard, about an inch wide, and I just put them in my platform as needed, either just for one edge, or the two to make a corner.