View Single Post
Old 09-14-2018, 02:18 PM   #21
Embri
Rubber Obsessor
 
Join Date: Nov 2008
Location: Ontario, Canada
Posts: 147
Default

I haven't had the best of luck with EK Success punches either. A multi-piece punch I bought locked up the first time it was opened - something misaligned and I couldn't get the punch to close again. It never even saw paper. Another I had, just a simple square, got jammed so badly cutting that it required replacement. Mostly it's been the big punches. I haven't had any issues with ones ~1" and smaller. All in all I've had less problems with wafer dies and prefer those. Easier to store, less expensive too.

Punches are mostly reserved for the shapes I use hundreds of times (circles) or that aren't easy to use with a press (corner punches).
Embri is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote