View Single Post
Unread 10-03-2012, 10:22 PM   #3
Barbara Jay
Hardware Hotshot
Join Date: Jan 2010
Location: Wisconsin
Posts: 4,174

Originally Posted by SherylH View Post
There is a way - but I have only read about it, never tried it. The instructions I have say to take the die-cut out of the die and place it on the back of the die. The sandwich I have for the Wizard is: white cutting plate, die with the cutting edge face down, the die-cut lined up on top of the die, embossing mat and then white plate. Hope that makes sense!
THANK YOU!! It worked.
I taped the second die cut to the back of the die with Scotch removable tape

Here is the CB sandwich:
from the bottom up

3 CS shims
Tan mat
die with cutting ridges down

Ah one more technique mastered LOL

Thanks again
"I have not failed . I've just found 10,000 ways that won't work" --Thomas A. Edison
Barbara Jay is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote