View Single Post
Old 09-24-2012, 10:14 PM   #12
Barbara Jay
Hardware Hotshot
Join Date: Jan 2010
Location: Wisconsin
Posts: 4,174

Originally Posted by Boss View Post
Before you panic, get a No More Shims embossing mat.

My original Cuttlebug has more scoosh- room between the rollers than my 2nd Cuttlebug (both are Version 1). I found that the no more shims embossing mat to be the perfect solution to my issue of needing a wide variety of shims. I also discovered that the No More Shims did not work in my tighter Bug - couldn't even crank it through.

Good luck with this!
Thanks! I will look into buying No More Shims. I don't use the metal plate. but after years of use my CB rollers are getting loose and the center doesn't cut cleanly anymore, even with new cutting plates . It still works so I don't want to buy another one until it is completely dead.
"I have not failed . I've just found 10,000 ways that won't work" --Thomas A. Edison
Barbara Jay is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote