View Single Post
Unread 09-05-2012, 05:46 PM   #631
Barbara Jay
Hardware Hotshot
Join Date: Jan 2010
Location: Wisconsin
Posts: 4,174

You may have a bad die, BUT it could be your machine. Sometimes the rollers have different pressure on one spot. The rollers on my Cuttlebug are getting loose from so much use and sometimes a die won't cut on the edges . I just turn the paper with the die attached and complete the cut
I personally have never had a bad Spellbinder die , and I own a gazillion of them but I am sure it can happen.

Try taping the die to the card stock with removable tape or a Post -It Note.
Run it through your machine. Then turn the die to have the uncut part on the other side of the machine and run it through again see if it cuts .
If not call Spellbinders. They are great and stand behind their products

The Spellbinder telephone number is 888-547-0400
"I have not failed . I've just found 10,000 ways that won't work" --Thomas A. Edison

Last edited by Barbara Jay; 09-05-2012 at 05:51 PM..
Barbara Jay is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote