View Single Post
Old 08-31-2012, 06:05 AM   #629
Rubber Obsessor
Join Date: May 2006
Location: Hemet, CA
Posts: 116

I have a Big Shot that comes with two B plates. I got so tired of trying one piece of paper and adding another piece of paper until I got the shim right that I bought the metal cutting plate AND a C plate from the Cuttlebug supplies. When I use a thin die, I use a B plate, A plate, die (cutting side up), paper, metal shim and the C plate. Since I've done that, I never have to guess about how many shims to add and it always works. I do use repositionable tape on the die and paper in case I have to move it around on the A plate, though. Sometimes it's hard to find the "sweet spot". Hope this helps.
junebugstamper is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote