View Single Post
Unread 10-08-2010, 11:29 PM   #24
Barbara Jay
Hardware Hotshot
Join Date: Jan 2010
Location: Wisconsin
Posts: 4,174

One of the suggestions to correct my stamp not stamping crisply was to see if it was uneven on the block.

I am having trouble with Dasher and it is on a wood mount.

I just looked at it very carefully after I realized it was rocking when I stamped down. The foam backing is "much thinner" under the body and legs than it is at the top under the antlers. The body is what is not inking or stamping properly.

The foam is already attached to the rubber from SU, so I didn't put it on wrong.

I really like it so I will have to buy another one. I can't return it. I have stamped it a gazillion times with every ink I could find trying to get it it stamp properly. Sheesh!
I guess in the future I better check the stamps to be sure they don't have defective EZ-mount on them
Barbara Jay is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote