View Single Post
Old 12-13-2009, 05:03 PM   #8
row4d
Stazon Splitcoast
 
row4d's Avatar
 
Join Date: Jun 2004
Posts: 14,640
Default

Quote:

Originally Posted by ScrapjannyView Post
I've been using the same maroon Marvy Uchida heat gun for over 7 years, and I've never had a problem with it. When I was an SU demo back in 2003, I think theirs was the same one, not the Milwaukee. I'm not positive about that, though.
Having used both brands extensively, I don't blame them one bit for making the switch! Seriously, I'd never use the Marvy one again if I could help it. Had to make 25 cards for my first demo swap, and as I approached the halfway point the embossing powder stopped melting smoothly and evenly. My VersaMark pad was juicy, I was embossing almost immediately after applying the powder, and I was using SU! powder the whole time so the only possible culprit was the heat gun!
__________________
Rachel
Proud SU! demo and Sci-Fi Geek!


My Stampin' Up! blog
"I'm a time traveler -- I point and laugh at archaeologists." 10th Doctor, "Silence in the Library"
row4d is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote