This is my first challange. It is a popcorn slider.
Here are the instructions as on the challange:
Here's how to do it:
Start with 6 3/4" by 10" piece of cardstock. This will be the part that wraps around the bag of popcorn still in the plastic. Check for fit...I don't know if popcorn bags are "standard"...this is what I used. Stamp as desired. Wrap the cardstock around the popcorn and adhere the overlapping edges so that the fit is snug, but not super tight.
Using a 1/4" square punch, punch a hole in the top center of wrapper about 3/4" down from the edge and another hole in approximately the same location in the back center of the wrapper. If you do not have a 1/4" square punch, simply punch two holes side by side with the little rectangle punch, creating a hole that is square. Do not make the holes too close to the edge of the sleeve, or it will rip.
Remove the popcorn from the sleeve. Cut a piece of ribbon about 20" long. Fold the ribbon in half, and place the bag of popcorn down against the fold. Hold the ribbons AND the popcorn at the opposite end of the bag from the folded ribbon, and insert the side popcorn bag with the fold of the ribbon into the sleeve. Push it all the way to the end of the sleeve. Thread one ribbon from the inside of the sleeve through the hole to the other side of the sleeve. Repeat with the other side. Tie the ribbons into a knot and trim.
Embellish as desired.
Date: Monday, October 15, 2007 GMT Views: 2053
Favorited:18