Registered: February 18, 2004 Location: pontiac, Michigan Posts: 1250
Sun, Sep 26, 2004 @ 7:26 PM
Hi: I posted all the directions for all my pop ups and slider cards under my "secret message pop up" on page 2 if you cant find it click on my user gallery and look for my secret message pop up card .. I think it is the 4th card over on top row then click on page 2 ... its very long so you cant miss it .. thanks for looking
HTH
Dawn
Registered: February 18, 2004 Location: pontiac, Michigan Posts: 1250
Fri, Sep 02, 2005 @ 2:35 PM
MONKEY SLIDER CARD :
base of card is measured at 5 1/2 X 11
Score on this part at 3 1/2"~ 3 1/2"~ 3 1/2"
when finishe you should have about 1/2 left over at one of your ends ..
Fold all scored lines
set aside ...
SLIDER PARTS:
Cut 2 pieces of white CS 3 " wide X 5 1/2" long
NOTE~ (one piece will be for top slider stamp images towards top and one will be for bottom slider ( stamp images towards bottom)
cut one strip of a plastic grocrey bag about an inch wide or so ...
should be long enough to wrap around your 5 1/2 " base
BACK TO BASE OF CARD :
you should have 3 panels of 3 1/2 " wide... On the last panel ( this will be inside your card to make slider ..)
wrap the grocrey bag plastic around this panel and attach it together ( plastic to plastic ...this step is very important) and mono the plastic to plastic together at the bottom of panel keeping it close to edge BUT not on the edge ) very important ....
next take one of your slider pieces ( 3" X 5 1/2") for the top slider glue this to the top of the plastic with stamped image facing up and out towards the front of card NOTE glue on plastic 1st at bottom and then attach the slider to that ( very important )
next open that panel we will attach the bottom slider flip the slider piece backwards and glue to the top are of panel of plastic ( glue plastic 1st then attach the slider part to plastic.. ( very important )
Now give it a test run...
when looking at your card when you pull the top ... both top and bottom should slide out at same time ...
if this is what happened
use sticky strip to attach the 1/2 end piece to close up your card making sure to keep slider working at all times
now punch hole into the top slider and attach ribbon to be able to pull and see message ...
Rubber hugs
Dawn Griffith