Registered: August 6, 2005 Location: Glennallen, AK Posts: 0
Mon, Apr 03, 2006 @ 10:41 PM
I used Elmer's Craft Bond Spray Adhesive to adhere the patterned paper, mini glue dots to adhere the letters, and went over the whole thing with a coat of Mod Podge to seal the edges of the paper.
As far as the tops, you just have to cut about a 3/4 inch section of your paper on the top and cut around the metal. I usually line the outer edge of the paper up and then take my nail and make an impression around the clip. Once you have the impression, you can cut the paper to match the shape of the metal clip. It was a little tricky at first, but once you practice a few times, it gets easier.