Stamp large medallion in Gumball Green on Whisper White and cut out with the framelit that fits the OUTSIDE shape. I left the center uncut because the next size smaller framelit cut off some of the inner edges of the stamped image. Instead, I cut a scallop out of the middle of a 4x4 square of Raspberry Ripple and simply layered it over the center of the medallion so when the medallion is layered on top of that same Raspberry Ripple 4x4 square and mounted to the Gumball Green card base, it gives the impression that I've cut the scallop out of it. And, where I punched the scallop out doesn't show because the medallion layer hides it. For the DSP at the bottom, I cut a strip into 2 narrower pieces and flipped one over. The dots side is at the bottom. The scallop side was punched with the ribbon punch, so it's a different pattern, but the little punched holes look like more dots. Stamped Sentiment and punched with Scallop Oval. Punched 2 more Scalloped Ovals from Gumball Green CS and layered behind the sentiment, one just above and one just below to give a shadow effect, then used dimensionals to pop it all up. Added a bow with long tails and rhinestones at the outer tips of the medallion. Gave it a 3, not all that difficult, just several steps.
Date: Saturday, October 19, 2013 GMT Views: 1513