Registered: July 31, 2004 Location: New York Posts: 201
Fri, Dec 09, 2005 @ 10:29 AM
Thank you all - Here are the instructions as given to me by Troublesmom:
Cut your card stock to size, my slides are 3 1/8 x 1 or there abouts. Stamp your design on the cut cs - if you have a xyron run them thru that on the side that has been stamped. Gently peel off paper backing from the xyron and I sprinkle a very tiny amount of dazzling diamonds on the design and then sandwich between two slides - no glue or anything. Take your Sticky Strip and run it around the edge of the two slides making sure it is centered around both slides ( this is what adheres the slides together) then peel the backing off the sticky strip making sure not to touch the tape, this does take practice. I have my micro mini beads poured out and into a plastic container so I can just lay each edge into the beads. If you have our Powder Pals this works well also, just try and keep your beads evenly spread on one side.
For the hanger I take a piece of cord and place a small piece of sticky strip (enough to cover it well)over the cord and place it at the back of the slide, peel off backing and adhere a small piece of white card stock to cover.
------------------------------ Happy Stamping and Scrapping, Maria