Registered: June 12, 2004 Location: United States Posts: 14
Mon, Jul 05, 2004 @ 5:36 PM
Where did you get the wheel template? How did you do this?
Registered: February 18, 2004 Location: pontiac, Michigan Posts: 1251
Mon, Jul 05, 2004 @ 6:46 PM
Thank you!!! actually I seen a card done with the pin wheel at the Ohio reginals seminar and thought it would be great for my business card swaps for convention the pin wheel is a 3X3 sq and then marked off with an X from corner to corner and then cut up to the center and mono the end to the middle until all the wings are in the center and then I punched a hole with my 1/16 punch and added a brad But i did not close the brad all the way in the back cause I wanted the wheel to turn.. I then stamped on my business cards with the "buisness memos stamp set" in all the colors that match the pix stick ( also just a note .... the pix stick is attached to the wheel with the brad also... I found the pix sticks at blockbuster video which is the only place i could find them.. So glad you like them... I heard that the folks at convention will be swapping business cards and also NON card items SO i think this fits both catagories huh? Being this is my 1st convention I have a lot of different style card fronts and also non card items too like Pens, marble items... so excited I will be leaving out tommorrow and stopping in TN for a few days to vist family and then its onto FLORDIA!! i cant believe how much space 200 swaps take up I may need to pack them in a whole suticase by them selfs Hee! Hee! the pin wheels are for sure the ones i want to swap out 1st only cause they are the most bulky to hold on to 30 of them ya know:-)