View Single Post
Old 05-26-2013, 11:30 AM   #21
Rebecca Ednie
Polyshrink Goddess
 
Join Date: Jul 2005
Location: Mt Albert, north of Toronto, Ontario, Can
Posts: 627
Default

I've cut one to separate a square design with a space in between what was essentially two corner designs. Left a huge line. I intend to sand it down. If doing it again if also stagger the cut lines slightly so they didn't end at exactly the same spot though in my case there was very little tolerance to do so. I hope sanding it down to bevel the edge will work. I expect it will.
__________________
Rebecca Ednie
www.eclecticendeavours.blogspot.com
Live Well, Laugh often, Love much
Rebecca Ednie is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote