New Honeycomb SU Folder and Nestabilities...

[Chautona]

Are the Nestabilities Hexagon dies compatible with this folder? I was thinking it'd be nice and convenient if I could just cut hexagons to fill those resessed places with the little dies if any were close to the right size. Does anyone know?

[charliemom]

good question - I was wondering if the honeycomb die matched the creative memories hexagon punch I have - anyone know if that works?

[charliemom]

okay - I see there is another discussion thread on this subject - says old creative memories punch will work for honeycomb SU folder - marvelous! now I'll have to add that embossing folder to my next SU order and make better use of my old CM punch

[Chautona]

I've read the small one works yes. I just wondered if I should risk buying those dies or not.

[Grandma Overboard]

The smallest die will sort of fit. Here's a couple of samples. One is staggered and you can see the embossed area. The other is next to each other and you cannot see the rest of the embossed area. It does not nest inside the embossed area as seen in these samples.

Hexagon by Grandma Overboard - Cards and Paper Crafts at Splitcoaststampers

Hexagon by Grandma Overboard - Cards and Paper Crafts at Splitcoaststampers

[AngelinYTH]

I haven't tried this yet but read that if you run DSP (patterned paper) through with the honeycomb folder, the little hexagons will pop right out.

[Chautona]

I'll have to try running paper through it. I just thought if you did that, you'd end up with hexagons that filled the honeycomb rather than rested in there.