Step1: slide on the bead
Snip 15cm long aluminum wire from the coil and slid the bead onto the wire. Stop the bead at about 1.8cm from the starting to serve as the ear-post.
Step2: wrap the wire around the bead
Firstly, bend the long end toward right side;
Next, start to wrap wire around your bead until you get a complete circle. Here the wire needs to go behind the wire as picture show;
Then, continue wrapping until the long end reach to the top part after three or more circles.
Finally, wrap the excess wire of long end around the ear-post.
Step3: ending work for post earrings
