View Single Post
Old 10-08-2012, 06:37 PM   #14
crazykim
Hardware Hotshot
 
crazykim's Avatar
 
Join Date: Apr 2006
Location: Under piles of craft stuff in New Zealand
Posts: 4,164
Send a message via Yahoo to crazykim Send a message via Skype™ to crazykim
Default

WOW -- thank you ALL for taking the time to help me with this issue. I re tried everything you all suggested and had no luck. This morning i did get a reply from Spellbinders and what they suggested did work to a point. Turning the die on a angle so the point of the tree was at 11.00 run through and then turn it so the point is 2.00 This is work but I cut out 6 trees and 3 out of the 6 still had areas that did not cut through so then ripped. I have decided to return the tree and they have given me a full refund. It is a stunning die and Spellbinders products are wonderful. Just his one for me was to much work for the cost. Again thank you all for being wonderful stampers and helping me. xxxxx
__________________
My Gallery --
http://www.splitcoaststampers.com/ga...0&ppuser=79891
Make me smile -- leave a comment on my gallery .....
crazykim is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote