View Single Post
Old 09-11-2012, 07:00 PM   #115
Scrapninny
Matboard Maniac
 
Join Date: Nov 2009
Location: Ontario, Canada
Posts: 336
Default

On cutting and embossing, Barbara Jay said:
Quote:
Then you remove the C plate and set up this sandwich from the bottom up A base -B plate-Die with CS in it ridges up - Tan mat- 2-3 CS shims-B plate and roll through .
But... doesn't the die then cut through your tan mat??

Shazsilverwolf said:
Quote:
I was getting a little fed up with seeing loads of dies etc that were too big for my 'bug. Or I wanted to emboss a slightly larger piece of card than would fit through the 'bug. So I looked at what was out there, and came to the conclusion that I wanted to make a 'one-off purchase', a cutter that would not be superseded by a bigger one almost before I got it out of the box!( Over the years I have bought a Quickutz Squeeze, an Original Red Sizzix, my 'Bug).
In the end, I went with the Big Shot Pro,because it would take up to 12x12 card/paper, and every die out there.
I'm with you. Same reason why I got the Accucut GrandeMark.
Scrapninny is online now  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote