View Single Post
Old 09-06-2012, 05:59 PM   #88
Barbara Jay
Die Cut Diva
 
Join Date: Jan 2010
Location: Wisconsin
Posts: 3,459
Default

Quote:
Originally Posted by Angie1974 View Post
Annette,



I also have an Epic 6, and generally I like it. I am wondering however, if you know how, when using Spellbinders dies, to die cut AND emboss. I understand the die cutting part, and I can usually see a very faint impression of the embossing, but I must be missing something. I would like to get a much more pronounced look with the embossing that is supposed to be possible with the die (s). Any ideas or suggestions you have would be great.

.
As far as I know you can not cut AND emboss in one pass with manual dies and I have been using them for over 4 years
You cut first and then emboss .

First you cut the die . With a Cuttlebug it is from the bottom up A base-C plate -Die cut side up-CS-B plate and roll through.

Then you remove the C plate and set up this sandwich from the bottom up A base -B plate-Die with CS in it ridges up - Tan mat- 2-3 CS shims-B plate and roll through .
Hope this helps
__________________
"I have not failed . I've just found 10,000 ways that won't work" --Thomas A. Edison
Barbara Jay is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote