View Single Post
Old 06-19-2012, 05:23 PM   #31
Ridiculously Obsessed
Matboard Maniac
 
Join Date: Oct 2006
Location: Beloit, WI
Posts: 382
Default

Update note.....Remember to put the wrong side of the die against the metal plate from Memory Box! I did it right the first time --and then flipped the die the otherway --and without thinking ran it thru the Cuttlebug. Made indentation in the metal! Hope it still will work! And - also - got a video to make the metal dies run better -----put small pieces of removal tape on the back of the die in the center where the die is not cutting thru right. Just build a layer or two of small strips! Works wonders! So much better! So - I had to also adjust my cutting layers -----A Plate --- piece of copy paper --B plate--metal plate --diecut UP --cardstock ---C plate! Works wonderful!
Ridiculously Obsessed is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote