View Single Post
Old 06-06-2011, 04:46 AM   #71
jmasse
Splitcoast Dirty Dozen Alumni
 
jmasse's Avatar
 
Join Date: Jan 2005
Location: Maine - Home of the Blackfly!
Posts: 4,625
Default

Quote:
Originally Posted by Miss Meowy View Post
I was over at my LSS, Mainely Stamping, for a cardmaking event where they were using the Easy Rosette CutUps Die.
And they made the rosette a little differently than I do. So I thought I'd share.

Currently, you make the rosette so that the end wedges overlap and the ends show up in the "mountain" of the rosette. They made it so that the end shows up in the "valley", where it's not as noticeable. It's all in the folding and the taping.

Here's what they did when they folded:
1) Place the rosette with the "right side" of the paper up.
2) Make sure the first fold is a "mountain" fold in the "right side"
3) Continue folding until the end. Do not attach the second rosette.
4) Take the second rosette and Repeat steps 1-3
5) Then overlap the two wedges at both ends. "Spooning" them, if you will.
6) Tape where the rosettes overlap.

It makes the cut edges almost invisible. Can you see them on this card?
Great tip Alma!! And your card is fabulous by the way!!
__________________
Julie Masse
Stampin With Julie ** Stamping Around ** Children's Challenge Corner
Design Team Member for: The Cat's Pajamas,
jmasse is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote