View Single Post
Old 01-28-2011, 04:36 PM   #429
Barbara Jay
Die Cut Diva
 
Join Date: Jan 2010
Location: Wisconsin
Posts: 3,535
Default

I just tried the Wizard magnetic mat in my Cuttlebug and it works!

I think you are trying to cut a large heart shape with the smallest heart shape inside of it , correct?

Normally I would use 1 "B" plate and 1 "C "plate to cut Nesties
For it to work with the Wizard magnetic mat I used "2 B" plates ( no C plate)

This is the stack I used from the bottom up

3 cardstock shims
B
Cardstock
magnetic mat with both heart dies on it ( ridges up)
B
A

Play around and see how many shims you need. I always start with the "least number of shims" and keep adding them until it cuts

If it works in the Cuttlebug there must be a sandwich that works in the Bigshot.

You may need to substitute a chip board shim for one cutting plate to allow for the depth of the magnetic mat . Set your sandwich as you normally use it, minus one cutting plate . Then play by adding cardstock or chipboard shims one at a time until it cuts.

Hope this helps

Last edited by Barbara Jay; 01-28-2011 at 04:42 PM..
Barbara Jay is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote