View Single Post
Old 11-10-2009, 06:35 AM   #105
debbiemom23cs
Hardware Hotshot
 
debbiemom23cs's Avatar
 
Join Date: May 2004
Location: Missouri
Posts: 4,631
Default

Quote:
Originally Posted by amydav View Post
You are very helpful! The actual dies I am looking at getting are the Santa's Workshop kit. They have a few dies that are long, open in the middle like spellbinders nesties. I was hoping to do what you suggested but was afraid that it may bend the dies as they come out of the machine. They are not solid like the grand dies ( I guess I could have given you this info before).
I'm not sure if these dies will bend or not, since I have never used them. Sorry. Maybe someone else on the SCS board will know?

Quote:
Originally Posted by amydav View Post
I would have to use the regular mats with these. So, if you happen to suggest doing the same with these then, I want to make sure the end of the die that is sticking out past my mat is facing the back end ( not the end I put into the rollers) ? Sorry for being a pain!
You are not a pain! And yes turn the mats to the part of the die sticking out is facing opposite of the rollers. Hard to explain! HTH I just can't answer too much about Quickutz dies, sorry.
__________________
Debbie Seyer
Design Team Member for Heartfelt Creations, The Rubber Cafe' and Craft Hoarders Anonymous!
My Blog- A Peek Into My Stamping Room
debbiemom23cs is offline  
Tweet this Post! Share on Facebook Reddit!! Pin on Pinterest! Share on Google+!
Reply With Quote