Ok I know I saw the answer to this somewhere but I can't find it now. I have an open house tomorrow which I'm showing off the big shot. I want to do a few things and don't want to really screw up.
1. Can I run somechipboard through my Xryon and attach DSP to it and then go through the BS?
2. If I do will the dies get gunky and how do you clean them?
3. This one is really ridculous but here goes. Does the DSP go up away from the cutting edge or right next to the cutting edge. I promise I will right that on my mat so I know and do do it backward when I demo it.